switch mode power supply + opto relay driver. Design & manufacture
Itemized price of each section for quantity of 1, 10, 500, 1000, 10,000
& price for design cost.
5 volt 1.5 to 2 amp p/s. 110 to 250 volts
must pass European standards, Rohs, rfi levels etc & USA, Australia.
2 mechanical 10amp relays with snubber circuit
2 iac outlets with fuses. hrc 10amp?
1 iac inlet
1 iac power in cord, and 2 short power out cords
2 Relay driver device.
Option for mains rocker switch and or secondary rocker switch on 5 volt line.
ability to measure mains power consumption to pass to arduino.
The unit is designed for an arduino to turn 2 separate mains outputs of and on. The unit will supply power to the arduino. The arduino should be able to measure the current drawn from the mains input. The arduino will drive the relays via a driver
Mechanical relay switch to go between the mains input and two iac mains outputs.
driver used to turn relays off & on from arduino outputs.
Simplified block diagram is included.