Hourly Rate: $30 - $40 / hr
| Duration: Not Sure
| Posted: Apr 24, 2015 | Ends: 6d, 11h |
We have need to develop a custom strain gauge using a small flexure. The flexure can be mounted on a small circuit board. A wire will pull on the flexure and we need a tab on the flexure that will hit a solder joint on the circuit board when the tension in the wire is 2, and 5 pounds of force. Plus or minus a pound. We have a similar device we have developed already but it is for a smaller load. I've attached a picture of our existing flexure. When force hits one pound the contacts hit and allow us to power off the device.
Hourly Rate: Not Sure
| Duration: 1-3 months
| Posted: Apr 21, 2015 | Ends: 2d, 22h |
We are looking for a designer of railway infrastructure products (see [obscured] ). Essential knowledge: Design work with Pro/E-Creo/Wind-chill Min. design experience of 3 years of products made of ductile cast iron Basic knowledge about the design of railway infrastructure products in track and turnouts During the start phase of co-operation we will order small design tasks. Based on the quality of work we will increase the design work volume.