Fixed Price: $1,000 - $5,000
| Posted: Jul 30, 2015 | Ends: 12d, 5h |
Job Responsibilities 1, develop, participate in or facilitate the implementation of related policies and the upper system; 2, responsible for the daily management of department staff and department management, guidance, training and assessment; 3, the development, maintenance and improvement of financial management procedures and policies, the development of annual and quarterly financial plan; 4, to provide the necessary financial reporting and financial analysis to the management company; 5, responsible for organizing the company's cost management work; 6, cost projections, control, accounting, analysis and assessment, to ensure the completion of the company's profit targets. Qualifications 1, accounting, finance, economics and other related professional degree or above, more than eight years of experience in financial management positions equivalent to more than three years of work experience; 2, familiar with the country's financial policy, corporate financial systems and processes...
Category: Chemical Engineering
Hourly Rate: Not Sure
| Duration: 1-2 weeks
| Posted: Jul 28, 2015 | Ends: 10d, 21h |
I am looking for someone familiar with 2G and 3G radio networks who can put together a presentation that introduces the concepts of cell tower mapping and tracking. We provide training for accounting, audit and billing professionals who work in telecoms and we want to help them learn how to read a cell site map and do basic assessment of capabilties. this will be EASY for a real radio network engineers. I am open to suggestions and fresh ideas in how to do this. Please respond with any good ideas of options.
Category: Other - Engineering &...
Fixed Price: Less than $500
| Posted: Jul 25, 2015 | Ends: 7d, 18h |
This is for a real world job involving the repair of an I-Beam steel girder supporting an existing bridge. A vehicle passing under the bridge hit one of the girders, causing damage to the bottom flange. The plan is to have the lower half of the I-beam cut out over a 10 foot length. The total length of the beam is exactly 50 feet, 7 inches. The center of the 10 foot section to be cut out is 20 feet from one end of the beam (in other words, the cut out section begins 15 feet and ends 25 feet from the end). The existing beam is a W-shape 30x108. Once the 10 foot section is cut out, we will place a 10 foot long WT 15x54 shape beam in its place. We will then place 3/4 inch thick steel plates on both sides of the new section's web the entire length of the new section (say, 12 to 15 feet or so). 3/4 inch steel plates will also be bolted to the underside of the bottom flange at each of the two cut locations. See the attached sketch of what this will look like (note that the steel plat...
Category: Civil & Structural